Proper Tree Removal Techniques
Step 2 – Inspect the Lean Next you want to observe the tree to see which way it naturally leans. This will tell you which way it will fall best.
Step 3 – Plan Your Escape Set up two escape routes that lead away from the expected fall line.
Step 4 – Remove Higher Branches (Optional) If you’re removing a large tree, especially one near any structures, you may want to take down the higher branches in stages. Secure any large sections with rope so you can control how they fall—make sure the ropes you attach support the branches before you saw them off.
Step 5 – Make Initial Cut Although you might not love it, it’s time to make the first cut to the trunk. Cut a 45-70 degree V shape. This should be done about 1/4th of the tree’s diameter in depth.
Step 6 – Make the Backcut Safety Note: This is the step that will cause the tree to fall. Be ready to yell “timber” and make sure no one is in the fall line before you make this cut. Make a backcut on the opposite side about two inches higher than the hinge part of the undercut. The purpose of the backcut is to release the stress on the backside of the tree, which allows it to fall in the direction of your V cut.
Step 7 – Remove Debris Remove the branches and stump to complete the tree removal.
A Few Don’ts in Tree Removal
Never make the backcut lower than the undercut, as you would be reversing the roles of the cuts in the tree removal process, causing the tree to fall the opposite way from the one you intended pruning.
Never cut all the way through the tree—you’ll risk losing control of the timing, and the direction it comes down.